Aluminum expands faster than steel when heat is applied. Ideally you want the steel hot, and the aluminum cold. 

Typical corrosives (WD-40, pb blaster, liquid wrench, etc.) have little affect on galvanic bonds. It's not what they're made to do. 

Theoretically, cleaning grade vinegar(acid) is more likely to weaken the bond. 

Discussion of bikebike2025 IRL are floating around Facebook and Discord. 


Luke Box
859.588.9811

On Tue, Aug 13, 2024, 1:39 PM Jim Sheehan via TheThinkTank <thethinktank@lists.bikecollectives.org> wrote:
- Aluminum foil (crushed lightly and dipped in water) is the best method for cleaning chrome: cheaper, faster, less abrasive than steel wool, and recyclable. Just wear gloves, wipe the brown drips off promptly with a thick, clean, cotton rag, and polish lightly with oil.

- Stuck seatposts usually are due to a missing -- or old, ineffective grease barrier between the steel tube and aluminum post. If you do not try to loosen it by flooding it with oil products first, there is a much better chance that the ammonia soaking trick will work, since it will be able to seep into the spaces where oil would have already sealed the less viscous ammonia away from contact.  Be sure to fill the post to overflowing, and give it at least a few days to sit. 

Looking forward to other contributions here!

Peace,
Jim

Jim Sheehan
Executive Director
Ohio City Bicycle Co-op
1779 Merwin St
_______________________________________________
TheThinkTank mailing list -- thethinktank@lists.bikecollectives.org
To unsubscribe send an email to thethinktank-leave@lists.bikecollectives.org
To view this discussion on the web visit https://lists.bikecollectives.org/hyperkitty/list/thethinktank@lists.bikecollectives.org/message/VTDJH2RUHKQBXPPQVLL7Z4JITBXRTYBN/