Yes, this is more of an advanced "Bike build" item rather than maintain/repair what left the factory. I do a rather in depth on lineal pull brakes because I so so many poorly adjusted. And I do mention that you can't swap the handles. That might be the place to throw in where to find the info to reference rather then a "common" repair.

Ron 

On Fri, Mar 9, 2018 at 9:42 AM, Jack Murphy <jack@bikewalkwichita.org> wrote:
Nice quick article. I pulled it down to our how-to's folder on our Drive. So many variations! Still trying to figure how to get all this info to volunteers as they learn. 
Jack Murphy
Bike Walk Wichita

On Fri, Mar 9, 2018 at 7:02 AM, David Oliver <nowhere3@gmail.com> wrote:
There are three ways that I teach people how to identify the difference.

First is the obvious one that if it says V-Brake on the brake, it's long pull.

Second is that if you look at most flat bar brake levers there are two holes, or at least an indent where a second hole could be, where the part that the head of the cable can go into is (the silver bit in this photo: https://www.parktool.com/assets/img/repairhelp/housingU_005.jpg). If it's in the top hole, then it's long pull. If it's in the bottom hole then it's short pull. There are sometimes a little "C" and a little "V" next to those holes/indent that make it even easier.

If that second one doesn't make sense, I can get a photo later today and send it to you.

Third is by measuring the distance from the pivot point to where the head of the cable goes. Park Tool says that it is 21mm for short pull: https://www.parktool.com/assets/img/repairhelp/ta-flatbar-conv.jpg and 42mm for long pull: https://www.parktool.com/assets/img/repairhelp/ta-linearpull.jpg

In practice for the third method I tell people to measure with a ruler the distance and if it's less than 30mm then it's short pull, if it's more than 35mm then it's long pull and if it's hard to tell or somewhere inbetween then it's hard to tell without testing it.

On Fri, Mar 9, 2018 at 7:25 AM, Ron Kellis <ron.kellis@velocitycoop.org> wrote:
Salvaged brake handles are rarely kept with the calipers. Anyone have a reasonably reliable method for identifying long pull vs. short pull handles?

TIA

Ron

--
Ron Kellis | Véloteer & Basic Maintenance Instructor  | VéloCity Bicycle Co-op | 2111 Mt. Vernon Ave., Alexandria, VA  22301 | velocitycoop.org | +1 (703) 549-1108

____________________________________

The ThinkTank mailing List

Unsubscribe from this list here: http://lists.bikecollectives.org/options.cgi/thethinktank-bikecollectives.org




____________________________________

The ThinkTank mailing List

Unsubscribe from this list here: http://lists.bikecollectives.org/options.cgi/thethinktank-bikecollectives.org





--
Jack Murphy
Jack@BikeWalkWichita.org

Support Bike Walk Wichita when you shop!
Dillons-Community-Rewards

Amazon-Smile


____________________________________

The ThinkTank mailing List

Unsubscribe from this list here: http://lists.bikecollectives.org/options.cgi/thethinktank-bikecollectives.org





--
Ron Kellis | Véloteer & Basic Maintenance Instructor  | VéloCity Bicycle Co-op | 2111 Mt. Vernon Ave., Alexandria, VA  22301 | velocitycoop.org | +1 (703) 549-1108